Nokia 2620 User Manual download pdf (Page 62)

Reference

You can change the USB and serial format settings

from the Interface tab. Do not change any of the other

settings unless you are an authorized Garmin installer

for the StreetPilot 2660.

Interface tab--StreetPilot 2660 Only

The Interface tab only appears on the StreetPilot 2660 with Dead Reckoning (DR) sensors. Most of

the information included in this tab is provided for and should be used only by authorized Garmin

installers who must install the Dead Reckoning (DR) cable for your StreetPilot 2660. If necessary, you can

customize the bottom-row settings on this tab (USB Format and Serial Format).

Your StreetPilot 2660 is set up to transfer data via a USB connection. If you need to use a serial port

connection, change the settings below as necessary:

USB Format

– If you are using the Garmin USB cable to transfer data, keep USB Format set to Garmin.

Change it to None only if you plan to use a serial cable instead of USB.

Serial Format – If you are using the Garmin USB cable to transfer data, keep Serial Format set to None.

If you plan to use a serial cable, choose from one of the available settings below:

• Garmin: The proprietary format used to exchange waypoint, route, track log data with a PC via serial

connection. Use this format for software updates and to save mapping software to the StreetPilot’s

pre-programmed hard drive.

• NMEA: Supports the input/output of standard NMEA 0183 version 3.01 data.

• Text Out: Supports a standardized, ﬁ xed-column ASCII output with data for position, track, speed,

etc.

• None: Provides no interfacing capabilities.

Note: Only the USB or the serial cable can be used at one time; you cannot use both at once. Thus, either

USB Format or Serial Format must be set to None.

Setting USB/Serial Formats

StreetPilot 2660 Only

190-00342-00_0A.indd 54 4/13/2004, 9:57:18 AM

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 93 94

No comments

Nokia 2620 User Manual Page 62